Anyone have a FSM handy or know what the torque spec is for the spindle nut and wheel bearing bolts?

Thanks

Hub bearing bolts are 85 lb ft.

Axle nut 81 ft :thumb:

thank you

hey does anyone know the torque spec of the lower control arm bolts ball joint bolts?

7215

Install the drivetrain and front suspension frame bolt (4) in the frame (6) and tighten the frame bolt (4) to 100 N·m (74 lb ft). Using an angle meter rotate the frame bolt (4) 180 degrees.
Install the front lower control arm brackets (5) and the lower control arm bolts (2) and tighten to 55 N·m (41 lb ft).
Install the front lower control arm (3) in the steering knuckle (1).

7216


Install the lower control arm bolt (3) in the steering knuckle (2).
Install the lower control arm nut (1) and tighten the lower control arm nut (1) to 50 N·m (37 lb ft). Reverse the nut 3/4 of a turn. Using an angle meter rotate the lower control arm ball stud nut (1) 30 degrees.

Good info & pics... All saved (of course).. :thumb: