Before winter, we finished the basic garage build up to pre-lift status. A summary of that project can be seen here:

http://www.garagejournal.com/forum/showthread.php?t=48782

In February, we ordered a BendPak HD-9, where we continue the project:

Lift transport:

http://photoshare.shaw.ca/image/4/8/6/122643/img_0113_svga-0.jpg

The tilt deck tow truck lowered the lift into the garage where I did the assembly using an engine cherry picker, floor jacks and profanity as required.

http://photoshare.shaw.ca/image/4/8/6/122643/img_0116_svga-0.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0130_svga-0.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0149_svga-0.jpg

Levelling plates were added to counter the 2.5 inch slope on the shop floor:

http://photoshare.shaw.ca/image/4/8/6/122643/img_016_svga-1.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0158_svga-0.jpg

The Z06 needs additional ramping to clear the rocker panels:

http://photoshare.shaw.ca/image/4/8/6/122643/img_0181_svga-0.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0188_svga-0.jpg

The Z06 which is lowered about 1 inch, is too low for the front end air dam to clear the RJ-45 rolling bridge, so the car is backed onto the lift, so that the rolling jack (stowed at the rear of the lift) clears the rear suspension and can be rolled up to the front end when required.

http://photoshare.shaw.ca/image/4/8/6/122643/img_0192_svga-0.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0196_svga-0.jpg

http://photoshare.shaw.ca/image/4/8/6/122643/img_0198_svga-0.jpg

Business end of the shop:

http://photoshare.shaw.ca/image/4/8/6/122643/img_0221_svga-0.jpg

Addition of the daily driver:

http://photoshare.shaw.ca/image/4/8/6/122643/img_0205_svga-0.jpg

My favorite shot:

http://photoshare.shaw.ca/image/4/8/6/122643/img_0207_svga-0.jpg

We have had a few teething problems with the BendPak HD-9, but Jeff Kritzer
at BendPak was very instrumental in helping to get resolution rolling. I was impressed that someone at such a senior level in the company would not hesitate to jump in to provide assistance. We are still sorting out a problem with primary safety lock operation, but I'm fairly certain this will get resolved.

Jacob

Thats awsome Im jealous.

OMG am I jealous!. BUT now I know what I'm doing in the 2 car garage. Thanks for the ideas!