It seems that the 07 2.2 has the same valve cover design as the 2.4, I'm just waiting to see if the CGS will fit the 07 with out moding it. Sorry about the crapy cell phone pics but the camera was dead.

http://www.chevyhhr.net/gallery/files/2/6/3/5/2.23.jpg

http://www.chevyhhr.net/gallery/files/2/6/3/5/2.21.jpg

http://www.chevyhhr.net/gallery/files/2/6/3/5/2.22.jpg

It will fit with no mods necessary. The CGS mounting strut fits under the bolt shown in your top photo (between the two plug coils). Like this:

The strut is barely visible in this pic:

http://img.photobucket.com/albums/v354/wfstudios/ValveCover1Good.jpg?t=1171330774

Hope it helps,

That should help the aftermarket manufacturers a lot.:thumb:

I have an 07 with a 2.2L auto. CGS tube fit just fine in my engine compartment. Only used the 2 tools that are listed in the directions. Took about 45 mins to instal

I've taken mine on and off a few time and now it maybe takes me 3 mins to change. I really got good when i was messing with that freakin "outlaw" filter to get it to stop rattleing.

But why replace a cold air intake with a warm air intake?

But why replace a cold air intake with a warm air intake?

Mostly looks and sound. All the other intakes are just as ugly if not worse than the original turtle.