Rendering rear body mods SS
01-14-2017, 08:06 AM
#32
Senior Member
Join Date: 09-07-2008
Location: Mebane, NC
Posts: 1,016
My HHR is a 3 Door. The previous owner welded the driver's rear door shut. He did a nice job. He said that's how the vintage Suburbans were. I think the old Suburban's were 2 door. Anyway, he did a nice job. Look at the pics. I like that the passenger rear door was retained, otherwise it would be very difficult to enter the back seats.
01-29-2017, 05:58 PM
#33
Member
Thread Starter
Join Date: 02-10-2013
Location: Fullerton,Ca
Posts: 98
Hey RJ.
I have not done any body mods yet. I am saving them for last.
Here are some of the things I have done so far.
New ZZP Crate motor
Line lock on the rear brakes. (With an SS shift knob with the button in the knob. Will also function as a Hill Holder.
BiXenon replacing the factory fog lights. (HiLo)
AquaMist Water injection. ( not completed yet)
Intercooler water spray
Water spray in the front wheel wells (to facilitate burnouts.
Custom dash gauge pods on either side of the steering wheel.
Custom center pod over the center storage bin (Water inj gauge, 3 switches, voltmeter
Custom CAI with air intake using the fog light grill.
Tri read IAT gauge, Before and after intercooler and flip a switch and it will read the CAI Temp
Relocated windshield washer bottle next to radiator.
Billet shifter to cable connectors (2)
Adjustable clutch cylinder
I have others in the works. Working on this project is a challenge and a great stress reliever.
I will keep you posted on other mods.
I have not done any body mods yet. I am saving them for last.
Here are some of the things I have done so far.
New ZZP Crate motor
Line lock on the rear brakes. (With an SS shift knob with the button in the knob. Will also function as a Hill Holder.
BiXenon replacing the factory fog lights. (HiLo)
AquaMist Water injection. ( not completed yet)
Intercooler water spray
Water spray in the front wheel wells (to facilitate burnouts.
Custom dash gauge pods on either side of the steering wheel.
Custom center pod over the center storage bin (Water inj gauge, 3 switches, voltmeter
Custom CAI with air intake using the fog light grill.
Tri read IAT gauge, Before and after intercooler and flip a switch and it will read the CAI Temp
Relocated windshield washer bottle next to radiator.
Billet shifter to cable connectors (2)
Adjustable clutch cylinder
I have others in the works. Working on this project is a challenge and a great stress reliever.
I will keep you posted on other mods.
01-30-2017, 08:26 PM
#35
Moderator
Join Date: 05-01-2014
Location: California
Posts: 7,791
Wow, you've been busy! 
I had heard of water injection, but was having a hard time wrapping my head around snow injection. How would you keep it from melting? Thanks for using an uppercase S in Snow, now I understand it is the manufacturer!!
I had heard of water injection, but was having a hard time wrapping my head around snow injection. How would you keep it from melting? Thanks for using an uppercase S in Snow, now I understand it is the manufacturer!!
Thread
Thread Starter
Forum
Replies
Last Post
vschriver
Problems/Service/Repairs
28
08-30-2010 06:07 PM