Rear Turn Signal
01-06-2009, 04:40 PM
#2
Senior Member
Join Date: 10-19-2005
Location: Miami
Posts: 20,687
01-06-2009, 06:10 PM
#6
Founding Member
Join Date: 11-23-2007
Location: Texas
Posts: 8,210
You are the second person to say that on this site. Strange deal. Must of been a production change. Since I don't know how the foam is secured I don't know how to tell you to get to them except to say start pulling.
01-06-2009, 06:36 PM
#7
Senior Member
Join Date: 03-07-2008
Location: Essex, Maryland
Posts: 361
Yes there is a foam insert..... it fits in really tight. No it is not glued in.
You just have to pull it out carefully so as not to rip it. I actually found it easier to start by pushing in on it first. I have had both of mine out to do trailer hitch wiring.
Pull out the plastic trim panel
Pull out the foam,
Unplug the wiring from the light
Turn the bulb holder appx. 1/4 turn. You can actually look in through the taillight lens and see which way you need to turn it. (It also helps to look through the lens to reinstall the bulb holder).
Pull the bulb out of the holder and replace with the new bulb.
Put it all back in reverse order..... take you all of 15 minutes tops
You just have to pull it out carefully so as not to rip it. I actually found it easier to start by pushing in on it first. I have had both of mine out to do trailer hitch wiring.
Pull out the plastic trim panel
Pull out the foam,
Unplug the wiring from the light
Turn the bulb holder appx. 1/4 turn. You can actually look in through the taillight lens and see which way you need to turn it. (It also helps to look through the lens to reinstall the bulb holder).
Pull the bulb out of the holder and replace with the new bulb.
Put it all back in reverse order..... take you all of 15 minutes tops
01-06-2009, 10:13 PM
#9
Senior Member
Join Date: 04-21-2007
Location: Anaheim Ca
Posts: 3,157
Yes there is a foam insert..... it fits in really tight. No it is not glued in.
You just have to pull it out carefully so as not to rip it. I actually found it easier to start by pushing in on it first. I have had both of mine out to do trailer hitch wiring.
Pull out the plastic trim panel
Pull out the foam,
Unplug the wiring from the light
Turn the bulb holder appx. 1/4 turn. You can actually look in through the taillight lens and see which way you need to turn it. (It also helps to look through the lens to reinstall the bulb holder).
Pull the bulb out of the holder and replace with the new bulb.
Put it all back in reverse order..... take you all of 15 minutes tops
You just have to pull it out carefully so as not to rip it. I actually found it easier to start by pushing in on it first. I have had both of mine out to do trailer hitch wiring.
Pull out the plastic trim panel
Pull out the foam,
Unplug the wiring from the light
Turn the bulb holder appx. 1/4 turn. You can actually look in through the taillight lens and see which way you need to turn it. (It also helps to look through the lens to reinstall the bulb holder).
Pull the bulb out of the holder and replace with the new bulb.
Put it all back in reverse order..... take you all of 15 minutes tops
