Replacing stock mids and tweeters in front, need help
#1
Replacing stock mids and tweeters in front, need help
I was wondering where the tweeter and mid are connected at.
The kenwood components I bought have an in line filter for the tweeters.
The tweeters connect directly from the 6.5"
Any ideas?
Also open to suggestions on other 6.5" components.
The kenwood components I bought have an in line filter for the tweeters.
The tweeters connect directly from the 6.5"
Any ideas?
Also open to suggestions on other 6.5" components.
#4
The wire splits under the dash by the front door pillar. From there it runs through a rubber grommet to door, other one to base of a-pillar.
For mounting aftermarket crossover/filter, you could put them at the back with the amps and run both sets of wires, or pull off the sides of the dash and mount them in the cavity.
Kenwood makes decent stuff.
For mounting aftermarket crossover/filter, you could put them at the back with the amps and run both sets of wires, or pull off the sides of the dash and mount them in the cavity.
Kenwood makes decent stuff.
Thread
Thread Starter
Forum
Replies
Last Post
Nazramoth
Audio and Video
8
11-22-2014 09:03 PM
hhrumadbruh
Audio and Video
0
04-15-2012 12:29 PM