Painted my headlights... Ya like???
03-19-2010, 03:12 PM
#1
Senior Member
Thread Starter
Join Date: 07-03-2009
Location: Blo-hio Transplant
Posts: 748
Painted my headlights... Ya like???
Just finished these the other day, wanted to see what everyone thinks.
I cut (yes cut) apart a set of GM stock lights (1 1/2 sets to be exact)
I know the Amber bulbs have to go. they are 1/2 coated (chrome dome) I installed a piece of Lexan where the old amber lense was.
I cut (yes cut) apart a set of GM stock lights (1 1/2 sets to be exact)
I know the Amber bulbs have to go. they are 1/2 coated (chrome dome) I installed a piece of Lexan where the old amber lense was.
03-19-2010, 07:59 PM
#8
Senior Member
Join Date: 06-21-2008
Location: SE Michigan
Posts: 1,449
I must have looked at that close up pic of the finished headlight for ten minutes trying to figure out what those orange things that looked like tiny jackstands in the headlight were......
Until I realized they were a reflection.....
Nice work, what did you use to cut the headlight apart?
Until I realized they were a reflection.....
Nice work, what did you use to cut the headlight apart?
03-19-2010, 09:00 PM
#10
Senior Member
Thread Starter
Join Date: 07-03-2009
Location: Blo-hio Transplant
Posts: 748
Mongo
I didn't see the stands reflection until I posted it then I was like, what the hell are those???
For the marker light cup i used a jewelers saw, like a baby coping saw.
For the head lights themselves I used a Dremel cut off wheel I found at Lowes
Cut around the entire out side, and under the lense. as stated in other posts the GM lights do not come apart in an oven like others do
I didn't see the stands reflection until I posted it
then I was like, what the hell are those???For the marker light cup i used a jewelers saw, like a baby coping saw.
For the head lights themselves I used a Dremel cut off wheel I found at Lowes
Cut around the entire out side, and under the lense. as stated in other posts the GM lights do not come apart in an oven like others do