Maybe helpful for front control arm rear bushings…
Thread Starter
Senior Member
Joined: 04-27-2021
Posts: 570
From: Alabama
Maybe helpful for front control arm rear bushings…
I have changed many of these over the years on many types of cars. Always dreaded it cause if they are hard to press in the outter shell can swell and they are ruined.
Recently I put some in my wife’s car (jetta but same, same) except I cut about 3” off bottom of aluminum can and put a small candle under it to heat it….and melted paraffin wax. I used an acid brush to coat the control arm bores and the bushing outer shells. Use a small hammer to get them started in straight….both went in the easiest I have ever done.
Hopefully be of help to someone else
Recently I put some in my wife’s car (jetta but same, same) except I cut about 3” off bottom of aluminum can and put a small candle under it to heat it….and melted paraffin wax. I used an acid brush to coat the control arm bores and the bushing outer shells. Use a small hammer to get them started in straight….both went in the easiest I have ever done.
Hopefully be of help to someone else
Administrator
Joined: 10-13-2011
Posts: 40,082
From: Welland,Ont Canada
Thread
Thread Starter
Forum
Replies
Last Post
alexrckid
Brakes | Suspension | Shocks | Struts
11
Feb 26, 2012 07:46 PM
