General HHR Discuss anything related to the Chevy HHR that doesnt seem to fit into the more specific categories below.

2007 hhr

Old Oct 11, 2024 | 08:41 AM
  #1  
Jesse2001$'s Avatar
Thread Starter
 
Joined: 10-11-2024
Posts: 5
From: tennesse
2007 hhr

Help or info needed !!!
I have a 2007 chevy HHR runs great but after about 15 mins out running it starts bogging down bad, Half to keep it above 2500 rpm or it will bog all the way out. you can turn it off wait about 20 mins and will run great for about 15 mins then its back to bogging down. Had a new fuel pump installed nut didnt help any at all. weird part is its not throwing any codes , looking for answers to what it could be, any help would be appricateed.
Old Oct 11, 2024 | 10:23 AM
  #2  
greg8453's Avatar
Senior Member
 
Joined: 03-29-2022
Posts: 1,241
From: Davison MI
Why the new pump? Did he test the system?
Need to test while it's 'bogging'.
Old Oct 12, 2024 | 07:17 AM
  #3  
Oldblue's Avatar
Administrator
 
Joined: 10-13-2011
Posts: 40,083
From: Welland,Ont Canada
Tighten the 4 bolts in the under hood fuse box, for a start, push all fuses and relays firmly into place. The bolts are 7 mm
Old Nov 8, 2024 | 10:45 AM
  #4  
Jesse2001$'s Avatar
Thread Starter
 
Joined: 10-11-2024
Posts: 5
From: tennesse
I tighten the 4 bolts but made no difference, I went ahead and replaced the Throttle body and the TPS , Didnt help anything , still runs about 15 mins then starts acting up, Could it be the ECM doing it ,when it gets hot ?
Old Nov 8, 2024 | 11:01 AM
  #5  
Jesse2001$'s Avatar
Thread Starter
 
Joined: 10-11-2024
Posts: 5
From: tennesse
I tighten the 4 bolts but made no difference, I went ahead and replaced the Throttle body and the TPS , Didnt help anything , still runs about 15 mins then starts acting up, Could it be the ECM doing...
Old Nov 8, 2024 | 03:15 PM
  #6  
PulpFriction's Avatar
Senior Member
 
Joined: 12-05-2014
Posts: 3,368
From: Northern Ohio
No CEL? No codes?
Old Nov 8, 2024 | 03:18 PM
  #7  
Jesse2001$'s Avatar
Thread Starter
 
Joined: 10-11-2024
Posts: 5
From: tennesse
Originally Posted by PulpFriction
No CEL? No codes?
only code it shows is P0449
Old Nov 8, 2024 | 04:05 PM
  #8  
donbrew's Avatar
Moderator
 
Joined: 01-23-2009
Posts: 26,532
From: Fredericksburg,VA
P0449 means that the EVAP vent solenoid is stuck closed. Try pouring gas out of a can with the vent closed.

Last edited by donbrew; Nov 19, 2024 at 04:27 PM.
Old Nov 19, 2024 | 02:18 PM
  #9  
Jesse2001$'s Avatar
Thread Starter
 
Joined: 10-11-2024
Posts: 5
From: tennesse
I Noticed if i unplug the Mass Air flow sensor and start it idles fine , shouldnt it run rough with that unplugged ?
Old Nov 19, 2024 | 03:04 PM
  #10  
Oldblue's Avatar
Administrator
 
Joined: 10-13-2011
Posts: 40,083
From: Welland,Ont Canada
Yes it should

Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:31 PM.