Dic and door locks
Thread Starter
Member
Joined: 04-27-2009
Posts: 53
From: GRIFFIN GA.
Dic and door locks
HELLO ALL. JUST A SMALL PROBLEM I CANT FIGURE OUT. I HAVE A 2008 HHR LT 2.4 AND WAS TRYING TO GET THE DOOR LOCKS TO STAY LOCKED WHEN I PUT IT IN PARK. THEY AUTOMATICALY UNLOCK WHEN PUT INTO PARK NOW. I READ THE MANUAL AND WHEN I HOLD THE RESET BUTTON AND INFO DOWN AT THE SAME TIME, I GET NO PERSONALIZATION MENU. I TRIED IT WITH MOTOR RUNNING, MOTOR OFF, IN PARK, IN NEUTRAL. ALL I GET IS THE STANDARD MENU, TIRE ,TRIP, MPG, AVG SPEED, ETC. WHAT AM I DOING WRONG?
Senior Member
Joined: 07-13-2006
Posts: 1,567
From: Geneva, FL.
Press and hold info & reset buttons at the same time for one second then release. then press the info. button to schrool through the settings. press the reset button to scroll through the setting on each mode you want to change.. Hope this helps.
Thread Starter
Member
Joined: 04-27-2009
Posts: 53
From: GRIFFIN GA.
Yea, thats just what i did, just like the manual said. Still would not go into personalization mode. Im wondering if its broke. I have no other problems with anything on the little car. Great ride
Moderator
Joined: 01-23-2009
Posts: 26,532
From: Fredericksburg,VA
Member
Joined: 09-04-2009
Posts: 86
From: Moab, UT
I have no idea on getting into the personalisation menu, it sounds like there is a problem that needs fixing. But in my vehicle there is nothing you can do to keep doors locked when the vehicle is put in Park. It even says so in the Owners Manual. The only thing that can be selected is unlocking the driver door or all doors. Good Luck with whatever happens.
Platinum Member
Joined: 01-09-2007
Posts: 16,081
From: SE USA
I have no idea on getting into the personalisation menu, it sounds like there is a problem that needs fixing. But in my vehicle there is nothing you can do to keep doors locked when the vehicle is put in Park. It even says so in the Owners Manual. The only thing that can be selected is unlocking the driver door or all doors. Good Luck with whatever happens.
If I an sitting somewhere & want the doors to remain locked with motor running, I just bump it into neutral & apply the park brake..
Senior Member
Joined: 10-19-2005
Posts: 20,687
From: Miami
Senior Member
Joined: 01-13-2006
Posts: 3,000
From: Superior, WI - Over the Hill Warranty Club member
Try Ignition off, Press and hold info & reset buttons at the same time, turn ignition only on (do not start the engine) then release. then press the info. button to scroll through the settings.
