ok, so Ive dyed the A pillars, and now Im ready to do the Bs... except I can't figure out how to get them around the seatbelt connector.... HELP! Ive go an 09, so its got airbags... I can see the top screw behind the airbag emblem, cant seem to get the seatbelt adjuster off...

any suggestions would be appreciated!

 

Here's an "exploded" diagram of the B-Pillar, hope this helps.

 

Mike, that diagram reminds me when I worked At TAKATA... I see a C9ST Retractor...

 

not reallly- its part 17 I cant fogure out how to get apart.... ugh...

 

I believe it just snaps off.

 

Be careful. It might just "snap off"(or break) as Mike stated. I took a quick look at mine and couldn't figure it out. But then again, I wasn't going to risk breaking mine just trying to find out.

 

I'll second your thoughts George, I spent a good fifteen minutes fiddling with that part this morning on Bob 2 the Panel with no success. So I pulled out the service manual when I got to the office, and its REALLY helpful, "remove cover, belt adjuster".....but it doesn't tell you how to do it.

 

the mystery continues.....

 

Ive done it and remembering it being pretty tricky. Dont take my word for it but if I remember right you undo a screw or two then it pops off, very stubborn pop off though.

 

they unclip from the bottoms... then you gently pull straight up and they pop right off... little scary but simple