Chevy HHR Network
Share Your Pictures with Our Community. Upload Now
0 2026/02/07 05:07:11
0 2026/02/07 05:05:32
0 2026/02/07 05:05:27
0 2026/02/05 15:08:38
0 2026/02/05 15:08:33
0 2026/02/05 15:08:29
0 2026/02/05 15:08:24
0 2026/02/05 12:40:17
The top left lug…one red wire to eps The bottom lug under the red cap is 2 wires . Push all those relays and fuses in tight! These are the ones Donbrew has mentioned!
The top left lug…one red wire to eps The bottom lug under the red cap is 2 wires . Push all those relays and fuses in tight! These are the ones Donbrew has mentioned!
0 2026/02/05 08:01:13
0 2026/02/04 11:45:44
0 2026/02/03 17:34:26
0 2026/02/02 06:19:19
Advertisement
Ground the dark green wire and the fan will run.
Ground the dark green wire and the fan will run.
0 2026/02/01 08:48:34
This is where it gets tough. You can easily lift the left side of the dash to get some access to the sensor, but it is difficult. If you wiggle the dash section forward and back it loosens a little, but not much, and didn't come entirely loose for me. If anyone knows how to loosen the right side of this section please comment. Note- make sure the speaker wires are in the clear when reattaching the dash.
This is where it gets tough. You can easily lift the left side of the dash to get some access to the sensor, but it is difficult. If you wiggle the dash section forward and back it loosens a little, but not much, and didn't come entirely loose for me. If anyone knows how to loosen the right side of this section please comment. Note- make sure the speaker wires are in the clear when reattaching the dash.
0 2026/02/01 06:25:11
Looking up through the glove box opening you will see 2 studs. Remove the nuts from each stud using the 11 mm socket and ratchet.
Looking up through the glove box opening you will see 2 studs. Remove the nuts from each stud using the 11 mm socket and ratchet.
0 2026/02/01 06:22:27
Lower the glove box door to gain access to the airbag nuts.
Lower the glove box door to gain access to the airbag nuts.
0 2026/02/01 06:21:22
Get a 10 mm socket with an extension, 1/4".
Get a 10 mm socket with an extension, 1/4".
0 2026/02/01 06:20:06
Remove the 2 Phillips screws above the instrument cluster.
Remove the 2 Phillips screws above the instrument cluster.
0 2026/02/01 06:18:16
Remove this screw with a 7 mm.
Remove this screw with a 7 mm.
0 2026/02/01 06:17:40
Remove the dash compartment by removing the 2 Phillips screws. The unit then pulls out.
Remove the dash compartment by removing the 2 Phillips screws. The unit then pulls out.
0 2026/02/01 06:16:36
0 2026/02/01 06:15:15
Remove the radio trim by prying outward about 2" down from the seam. Pull the trim out and tilt the section outward. It is not necessary to remove this part or disconnect the wiring.
Remove the radio trim by prying outward about 2" down from the seam. Pull the trim out and tilt the section outward. It is not necessary to remove this part or disconnect the wiring.
0 2026/02/01 06:12:16
Disconnect the speaker.
Disconnect the speaker.
0 2026/02/01 06:11:29
Remove the cap at the top of the pillar trim and remove the 7mm screw. The trim pulls up and out.
Remove the cap at the top of the pillar trim and remove the 7mm screw. The trim pulls up and out.
0 2026/02/01 06:10:25
0 2026/02/01 05:56:06
0 2026/01/29 17:12:18
0 2026/01/29 17:12:12
0 2026/01/29 16:58:31
0 2026/01/29 16:58:26
0 2026/01/29 07:46:15
0 2026/01/29 07:33:26
0 2026/01/29 07:32:00
Advertisement