Chevy HHR Network
The rolled fibreglass visor this one on A&P’s panel”Morticia “
The rolled fibreglass visor this one on A&P’s panel”Morticia “
0 2022/01/10 06:00:10
Another angle, same brand Visor
Another angle, same brand Visor
1 2022/01/10 06:00:11
And the same visor just on the original HHR, this one ended up on Morticia, then back on another HHR owned by this member. All of these required cutting the windshield side molding, but the rolled visor, to me is most appealing
And the same visor just on the original HHR, this one ended up on Morticia, then back on another HHR owned by this member. All of these required cutting the windshield side molding, but the rolled visor, to me is most appealing
1 2022/01/10 06:00:13
Rust paint bubble removed, sanded primer Ed and painted
Rust paint bubble removed, sanded primer Ed and painted
0 2022/01/11 11:26:04
Hard to see, small paint bubble from rust just above the right rear tire.
Hard to see, small paint bubble from rust just above the right rear tire.
0 2022/01/11 11:26:09
Larry Watson had the knack to hide paint mismatch and stone chips , door dents
Larry Watson had the knack to hide paint mismatch and stone chips , door dents
0 2022/01/11 13:18:51
Even the worn area on the window sill, stone chips in the hood and headlight eyebrows, the guy was a genius!
Even the worn area on the window sill, stone chips in the hood and headlight eyebrows, the guy was a genius!
0 2022/01/11 13:18:52
They do have a kick to them
They do have a kick to them
0 2022/01/11 13:30:11
A no touch foam cannon wash and the Stubby antenna installed!
A no touch foam cannon wash and the Stubby antenna installed!
0 2022/01/12 08:53:24
Solenoid robots ! And the hero of the nation Roger Ramjet!
Solenoid robots ! And the hero of the nation Roger Ramjet!
0 2022/01/14 06:20:38
0 2022/01/14 10:37:00
My trusty 1978 MTD 24 inch 2 stage at the ready! It wards off snow, I really only need it when it’s not ready!
My trusty 1978 MTD 24 inch 2 stage at the ready! It wards off snow, I really only need it when it’s not ready!
0 2022/01/14 14:45:35
0 2022/01/15 08:55:15
#1 is the ECM #2 is the BCM
#1 is the ECM #2 is the BCM
0 2022/01/16 03:19:59
This red light lites up for fresh outside air. The other light is for the recirculating air and working with the fan switched on and the selector switch on the right in certain positions
This red light lites up for fresh outside air. The other light is for the recirculating air and working with the fan switched on and the selector switch on the right in certain positions
0 2022/01/17 09:33:08
Try logging out then back in
Try logging out then back in
0 2022/01/20 13:21:12
Jeanie has been up to mischief again!
Jeanie has been up to mischief again!
0 2022/01/20 13:22:02
That black plastic cap covers the schrader valve
That black plastic cap covers the schrader valve
0 2022/01/20 14:49:01
0 2022/01/24 11:33:32
Looks like they were finished.
Looks like they were finished.
0 2022/01/25 04:22:46
This is snow!
This is snow!
0 2022/01/27 14:19:04
0 2022/01/27 14:29:12
0 2022/01/27 14:29:18
A screen shot of the PM I received for my post getting moved, no link provided.
A screen shot of the PM I received for my post getting moved, no link provided.
0 2022/01/29 08:41:51
Like this, coolant temperature sensor? Could the black gunk in it insulate or isolate the correct coolant temperature readings? Telling the computers it’s cold! More fuel please!!!
Like this, coolant temperature sensor? Could the black gunk in it insulate or isolate the correct coolant temperature readings? Telling the computers it’s cold! More fuel please!!!
1 2022/01/30 05:38:45
The cv axle goes thru the hub and is secured with that 30 mm nut in the middle, sometimes it gets corroded in there, perhaps no anti seize was put on the splines. Most times a swat with a BFG will break it loose. That can damage the cv joints in the axle, the ball joint also. If the alignment is out, it’s either the tie rods ends worn out or the rear lower control arm bushings.
The cv axle goes thru the hub and is secured with that 30 mm nut in the middle, sometimes it gets corroded in there, perhaps no anti seize was put on the splines. Most times a swat with a BFG will break it loose. That can damage the cv joints in the axle, the ball joint also. If the alignment is out, it’s either the tie rods ends worn out or the rear lower control arm bushings.
0 2022/02/01 10:17:26
Yes a hub buster , they work
Yes a hub buster , they work
0 2022/02/01 13:25:57
Some even inexpensive scanners can read the alcohol percentages. This one is way to high.
Some even inexpensive scanners can read the alcohol percentages. This one is way to high.
0 2022/02/02 04:01:35
0 2022/02/05 16:57:58
0 2022/02/06 06:44:28
0 2022/02/06 06:45:16
0 2022/02/06 07:41:31
0 2022/02/06 09:51:04
Add more speakers, add more thump!
Add more speakers, add more thump!
0 2022/02/06 14:30:50
0 2022/02/06 14:33:12
Saab 9-3 , 2001 vintage looks more similar to the HHR SS
Saab 9-3 , 2001 vintage looks more similar to the HHR SS
0 2022/02/07 07:17:57
Saab 9-5 rear suspension looks more G6 or Impala
Saab 9-5 rear suspension looks more G6 or Impala
0 2022/02/07 07:17:59
Not an SS but there to the left of the fog light switch
Not an SS but there to the left of the fog light switch
0 2022/02/07 16:56:25
0 2022/02/10 13:44:10
0 2022/02/10 17:11:59