Chevy HHR Network
I had to sell Oldblue to get the BlackSwan
I had to sell Oldblue to get the BlackSwan
0 2022/12/26 08:50:16
From all of us at Chevyhhr.net and Internet Brands !! Be safe, stay warm, enjoy the day with your family and friends!
From all of us at Chevyhhr.net and Internet Brands !! Be safe, stay warm, enjoy the day with your family and friends!
0 2022/12/24 14:08:46
Like in the centre photograph
Like in the centre photograph
0 2022/12/24 13:36:43
Like this.
Like this.
0 2022/12/24 13:35:02
0 2022/12/24 10:03:01
This is upside down but it shows the 3 bolt holes and the CTS threaded hole location. A 19 mm deep socket and 3/8 ratchet works good to remove or replace the sensor.
This is upside down but it shows the 3 bolt holes and the CTS threaded hole location. A 19 mm deep socket and 3/8 ratchet works good to remove or replace the sensor.
0 2022/12/24 09:59:35
That broken front guide!
That broken front guide!
0 2022/12/24 07:55:15
If your look like this, those are the 1LT rims, they came with a chromed plastic cover
If your look like this, those are the 1LT rims, they came with a chromed plastic cover
0 2022/12/24 04:49:55
0 2022/12/23 12:29:30
This one it’s a 21 mm use a pry bar or large screw driver to hold the harmonic balancer to loosen that bolt.
This one it’s a 21 mm use a pry bar or large screw driver to hold the harmonic balancer to loosen that bolt.
0 2022/12/23 12:23:49
The mirror button for compass and that light button for map light.
The mirror button for compass and that light button for map light.
0 2022/12/20 14:09:43
0 2022/12/20 11:32:41
Here’s a photo of the block side and the strange oring that becomes square when you install it.
Here’s a photo of the block side and the strange oring that becomes square when you install it.
0 2022/12/15 11:08:03
To get the bolt out from between the heater lines, you must remove the coolant temperature sensor, this photo is upside down
To get the bolt out from between the heater lines, you must remove the coolant temperature sensor, this photo is upside down
0 2022/12/15 11:08:01
With the water pump bolted on no you can’t see much , however the cylinder head does sit just above the water pump, you should be able to see better once the pump is removed
With the water pump bolted on no you can’t see much , however the cylinder head does sit just above the water pump, you should be able to see better once the pump is removed
0 2022/12/15 09:50:45
Here’s a look from the water pump mount side , it could be the gasket just above the round hole where the water pump bolts up!
Here’s a look from the water pump mount side , it could be the gasket just above the round hole where the water pump bolts up!
0 2022/12/15 09:50:42
From the top of the block see the water jackets, over on the left by the water pump. Possible leak area
From the top of the block see the water jackets, over on the left by the water pump. Possible leak area
0 2022/12/15 09:50:37
Everything you need! Did you read the engine assembly instructions I posted?
Everything you need! Did you read the engine assembly instructions I posted?
0 2022/12/13 11:58:45
Front seal another must have, I also replaced a FelPro seal that leaked after a few months.
Front seal another must have, I also replaced a FelPro seal that leaked after a few months.
0 2022/12/13 10:21:03
Same with the front cover, I replaced a 3 month old FelPro gasket with this one.
Same with the front cover, I replaced a 3 month old FelPro gasket with this one.
0 2022/12/13 10:20:59
Valve cover gasket set at your cars age give it a new one!
Valve cover gasket set at your cars age give it a new one!
0 2022/12/13 10:20:54
Front guide replacement bolt. A must have!
Front guide replacement bolt. A must have!
0 2022/12/13 10:20:50
0 2022/12/13 08:20:40
That red wire in the top left corner of the fuse box is the wire going to the EPS , the yellow first fuse on the left of that top row is the fuse for the EPS . Tighten those 5 bolts gently but firmly until they can’t be tightened anymore.
That red wire in the top left corner of the fuse box is the wire going to the EPS , the yellow first fuse on the left of that top row is the fuse for the EPS . Tighten those 5 bolts gently but firmly until they can’t be tightened anymore.
0 2022/12/10 16:54:43
The website has rad cap replacement options also
The website has rad cap replacement options also
0 2022/12/09 05:42:49
Specifications from their web site.
Specifications from their web site.
0 2022/12/09 05:25:32
My comments on their website
My comments on their website
0 2022/12/09 05:25:29
This is where the battery lives, the smaller red part in the upper portion of the photo is the maxi fuse. That needs to be inspected , is it burnt? Is it loose?
This is where the battery lives, the smaller red part in the upper portion of the photo is the maxi fuse. That needs to be inspected , is it burnt? Is it loose?
0 2022/12/08 16:43:32
0 2022/12/06 11:06:14
Letterman 7 did the conversion. And many others . I suggest you swap the front rotors and calliper brackets to SS non Brembo, the increased rotor diameter really helps!
Letterman 7 did the conversion. And many others . I suggest you swap the front rotors and calliper brackets to SS non Brembo, the increased rotor diameter really helps!
0 2022/12/06 08:49:21
The water pump I have in the BlackSwan
The water pump I have in the BlackSwan
0 2022/12/05 12:41:51
If there is a break at the welds, pressure can’t be maintained
If there is a break at the welds, pressure can’t be maintained
0 2022/12/05 08:15:56
Those are 2006 2LT polished aluminium 17” rims
Those are 2006 2LT polished aluminium 17” rims
0 2022/11/26 12:37:58
0 2022/11/26 12:37:52
0 2022/11/26 12:37:47
0 2022/11/25 09:48:24
Enjoy a safe and happy Thanksgiving! From all of us here at chevyhhr.net and Internet Brands!
Enjoy a safe and happy Thanksgiving! From all of us here at chevyhhr.net and Internet Brands!
0 2022/11/24 06:44:31
See it over there on the right end of the pipe!
See it over there on the right end of the pipe!
0 2022/11/24 06:05:55
This piece I cut from a Cobalt at a parts yard, longer to move that connector back by the fire wall
This piece I cut from a Cobalt at a parts yard, longer to move that connector back by the fire wall
0 2022/11/22 08:25:23
Thi was to far to the solenoid, but you can see the white retainer clip
Thi was to far to the solenoid, but you can see the white retainer clip
0 2022/11/22 08:25:22