Keyless entry
I searched but didn't find exactly the issue I'm having. My keyless entry is having an intermittent problem, I push the unlock or lock & sometimes get nothing. Other times it works fine and I'm not getting any message on the dash about low battery in my fob or anything. Dealer said that 9 times out of ten, it's not the fob, of course it worked just fine when I stopped at the dealership. Any suggestions or similar problems? Thanks everyone in advance.
|
Key FOB.....
Cold ,craked joint on cuircit board. See early post on same.
|
Thanks, got a link?
|
Originally Posted by Silver bullet
(Post 432411)
Thanks, got a link?
Don:nuts::nuts::nuts: |
Originally Posted by donbrew
(Post 432414)
It's the first sticky in the HOW-TO section
Don:nuts::nuts::nuts: |
General Discussion > How To Guide. Sorry I Am bad at links. You are in General Discussion > Problems/Service Issues.
|
Ah, here it is- https://www.chevyhhr.net/forums/how-tutorial-library-21/keyfob-cold-solder-repair-22641/
Thanks much. Next question, if I pull out the battery, I don't have to reprogram or anything do I? |
I don't know about 2009, I'd be more worried about the radio. The fob is matched to the BCM, so I think backup memory/power would keep the programming. I am over my head here. I believe that one of those 9-volt battery adapters that plug into the cig lighter would make the Question moot.
|
Originally Posted by Silver bullet
(Post 432420)
Ah, here it is- https://www.chevyhhr.net/forums/showthread.php?t=22641
Thanks much. Next question, if I pull out the battery, I don't have to reprogram or anything do I? |
Originally Posted by Sno White
(Post 432542)
I think Silver was taking about removing the battery in the FOB, not the vehicle's battery. If so no problem. Some of the older vehicles have had a problem with the remote receiver module in the vehicle or BCM loosing programming with total power loss in the vehicle.
|
All times are GMT -5. The time now is 02:11 PM. |
© 2024 MH Sub I, LLC dba Internet Brands