Finally Getting TUNED on Wed.
Thread Starter
Senior Member
Joined: 05-13-2008
Posts: 2,075
From: Knoxville, TN
Finally Getting TUNED on Wed.
Merry X-Mass to me! I was finally able to get the GMPD Stage 1 Tune and it will be installed on Wed of this week here in Talle. I will be printing out all the TSB's that have been posted, (thank-you ChevyMgr!) to help make the install easier since Champion Chevy hasn't done one of these yet.
I will be pointing out:
1.wrong pin labeling
2. Moving radiator foward
3. rubbing wires
Is there anything else major I should be aware of before wed. that I can tell the Tech.?
I will be pointing out:
1.wrong pin labeling
2. Moving radiator foward
3. rubbing wires
Is there anything else major I should be aware of before wed. that I can tell the Tech.?
Senior Member
Joined: 08-03-2008
Posts: 890
From: San Diego
Soldering is recommended as opposed to using the butt splices the kit comes with. Not sure about the radiator issue, but many have had charge pipes come loose, so have them check those, and the lower new sensor can be too close to the a/c compressor I believe it was and hit that under hard throttle.
Thread
Thread Starter
Forum
Replies
Last Post
