Did my overlays. Looks like MY SS now!
12-23-2012, 04:24 PM
#11
Platinum Member
Join Date: 12-06-2009
Location: Alabama
Posts: 11,112
The grill SS is the same size as the rear.
I made a bracket/plate to stick the emblem to. It bolts through the grill so I can remove it if needed.
The back part is just some scrap plastic I had. The lag screw/bolts were inserted, then excess threads ground off.
The picture shows the completed emblem/mount with an extra set of the
bolt/screws I used. The red washer things just fill in the grill hole opening.
I made a bracket/plate to stick the emblem to. It bolts through the grill so I can remove it if needed.
The back part is just some scrap plastic I had. The lag screw/bolts were inserted, then excess threads ground off.
The picture shows the completed emblem/mount with an extra set of the
bolt/screws I used. The red washer things just fill in the grill hole opening.
12-23-2012, 04:29 PM
#12
Senior Member
Thread Starter
Join Date: 12-04-2009
Location: Port St Lucie, Florida
Posts: 463
The grill SS is the same size as the rear.
I made a bracket/plate to stick the emblem to. It bolts through the grill so I can remove it if needed.
The back part is just some scrap plastic I had. The lag screw/bolts were inserted, then excess threads ground off.
The picture shows the completed emblem/mount with an extra set of the
bolt/screws I used. The red washer things just fill in the grill hole opening.
I made a bracket/plate to stick the emblem to. It bolts through the grill so I can remove it if needed.
The back part is just some scrap plastic I had. The lag screw/bolts were inserted, then excess threads ground off.
The picture shows the completed emblem/mount with an extra set of the
bolt/screws I used. The red washer things just fill in the grill hole opening.
IM me with how much you'd charge to do that!
I'm in an apartment for right now and have none of my tools or time.
12-23-2012, 05:12 PM
#14
Platinum Member
Join Date: 12-06-2009
Location: Alabama
Posts: 11,112
Not like it's a hard thing to make. A razor knife, handfile and some sand paper would work. ( I used a jigsaw and benchgrinder) Sit in front of the TV and cut it out.The SS emblem has 3m tape on back. You could always just stick it on.
Thread
Thread Starter
Forum
Replies
Last Post