Its alot of hard work and love to do what I have just started. Oh and sore hands and fingers. I am hand polishing the cover for my cams on the 2.2.
It isnt as easy as it sounds. It is alot easier if you can remove your cover while you do this. I started off with 400 grit sand paper. Then worked up to 800 then to 1000. After all is at a nice flat finish take and clean all the dust off. Then take your fav chrome polish and take your time work it. You may have to go over some spots again with 1000 grit to get it nice then polish it again. I will take some pics soon and try to figure out how to put them on here. Sorry no before pics but it does look awsome now. I would assume that it would be easier if you did it with a rotory tool but becarefull because you can dig in more then you need to with that tool. Trust me I know. Thank god it was in a spot no one can see.

 

Looking forward to seeing pictures of your project when you are done.

Fallen Saint posted a great HOW TO on uploading and posting pictures HERE.

 

 

That looks way better!

 

WOW!!!


How long did that take you?

 

another veiw I dont claim to be the best pic taker lol. looks better in person.
I would have to say 5-6 hours total to get to this point. I think i may take it back off and do abit more to it.

 

How much HP did it add?

 

The hardest part to do is the ends in the indents. Hands and fingers def get a work out on this one. Best thing is if you are really carefull you can take it off a few times since its a rubber gasket. Oh I used mother polish on it.

 

I think it added ummm none but it looks good lol but funny part is I still need to get CAI so you can see the dang thing lol. Kinda covered for now by the air cleaner crap.

 

Looks like the AirAid CAI is out of the question!