General HHR Discuss anything related to the Chevy HHR that doesnt seem to fit into the more specific categories below.

What Did You Do To Your HHR Today?

Thread Tools
 
Search this Thread
 
Old Jun 4, 2019 | 01:27 PM
  #16821  
HHRman07's Avatar
Member
 
Joined: 09-07-2011
Posts: 72
From: Tennessee
Originally Posted by Vinnybagodoughnuts
Absolutely.It's also really good at protecting all the plastic in the interior.https://www.amazon.com/303-30382-Pro...-2-spons&psc=1
Thanks.
Old Jun 4, 2019 | 03:29 PM
  #16822  
Cat Man HHR's Avatar
Senior Member
 
Joined: 08-03-2010
Posts: 3,564
From: Lake Ronkonkoma, N.Y.
Originally Posted by Ron S
Cat Man HHR where did you get your Cruz horns?
Ebay, here's one listing. Spell Cruze the correct way. Sorry I spelled it wrong.
https://www.ebay.com/itm/Chevrolet-G...YAAOSwHLNZOR~y
Old Jun 4, 2019 | 03:34 PM
  #16823  
Cat Man HHR's Avatar
Senior Member
 
Joined: 08-03-2010
Posts: 3,564
From: Lake Ronkonkoma, N.Y.
[QUOTE=Oldblue;867230]Was it this horn kit?

Found my "How To"
https://www.chevyhhr.net/forums/how-...l-horns-56321/
Old Jun 4, 2019 | 08:17 PM
  #16824  
sleeper's Avatar
Platinum Member
 
Joined: 01-09-2007
Posts: 16,081
From: SE USA
Originally Posted by PittKrewBowling
I bet that sounds sweet!
I certainly think so, that anemic single OE horn was embarrassing..
Old Jun 5, 2019 | 07:02 AM
  #16825  
Vinnybagodoughnuts's Avatar
Senior Member
 
Joined: 02-17-2016
Posts: 228
From: Florida
Originally Posted by Cat Man HHR
Ebay, here's one listing. Spell Cruze the correct way. Sorry I spelled it wrong.
https://www.ebay.com/itm/Chevrolet-G...YAAOSwHLNZOR~y
Just be aware that listing is for one horn only.
Old Jun 5, 2019 | 07:06 AM
  #16826  
PulpFriction's Avatar
Senior Member
 
Joined: 12-05-2014
Posts: 3,349
From: Northern Ohio
Surprise success, no replacement part needed.

2008 mirrors would only move in one direction. Suspected a bad switch, of course.

Very easy to remove; just two torx screws in the door pull. Discovered I could take the switch assy apart - snap assembled - so I decided to try a repair before replacing.

I cleaned all the contacts on the the little p.c. board with a pencil eraser and buffed with a clean rag, taking care not to touch after that. (Have done this several times to keyless entry fobs.) Didn't touch the copper contacts embedded in the silicone rubber button pad.

It worked!

Last edited by PulpFriction; Jun 5, 2019 at 12:19 PM.
Old Jun 5, 2019 | 01:03 PM
  #16827  
PittKrewBowling's Avatar
Senior Member
 
Joined: 05-15-2017
Posts: 264
From: Garland, TX.
Originally Posted by HHRman07
Old and new Headlights.
While I was doing it I replaced the bulbs wit Silverstars. But since I rarely drive at night any more they should last a long time.

Had Old fogged headlights when I bought it

Bumper cover off... not too hard

Bumper cover off and one headlight out.

Finished!

New Eyes!
The last car I had, I replaced the old yellow headlights and I had to aim them. Each headlight had 2 screws to adjust pitch. Did you have to aim these headlights?
Old Jun 6, 2019 | 09:33 AM
  #16828  
Lethal Tendencies's Avatar
Senior Member
 
Joined: 12-26-2009
Posts: 819
From: Hebron, Ill.
replaced rear door speakers with sony explode speakers. the sony's bolted right in with out modifying the holders
Old Jun 6, 2019 | 10:14 AM
  #16829  
Oldblue's Avatar
Administrator
 
Joined: 10-13-2011
Posts: 39,970
From: Welland,Ont Canada
Washed and detailed yesterday, when out for dinner, got rained on and detoured down a dirt farm road.
So, today a wash and detail, a we are off to Fort Erie, burgers and a beer with friends.
Old Jun 6, 2019 | 12:16 PM
  #16830  
Cat Man HHR's Avatar
Senior Member
 
Joined: 08-03-2010
Posts: 3,564
From: Lake Ronkonkoma, N.Y.
Originally Posted by Vinnybagodoughnuts
Just be aware that listing is for one horn only.
One horn is for two as an assembly. Look at it again.
Thanks



All times are GMT -5. The time now is 08:40 PM.