I have Hahn IC piping and now a hahn IC. I'm having an issue with my ac pressure switch on the pass side being WAY too close to the piping, before the IC, with just the aftermarket piping, the sensor on the pipe would rub against my switch wires and caused it to have a short. Now that I have the IC installed everything is fitting even tighter. Anyone running into a fitment issue right at the ac compressor like this?

 

Lots of issues out there with this .
I did lIke some others have on here and turned the lower tmap sensor 180 degrees.
One of the Best mods to date.
lots of info in here on that mod

 

i thought Hahn's piping already was set up to switch the t map the other way? i dont know if it has the same tabs that the stock pipe has.....
just my 2 cents