Front unibody dropped sittin on 22 inch wheels, 1964 Chevy impala tail lights, Shaved door handles, TVS 900 Webasto Sunroof, Genuine Full wrap Sharkin/Stingray/Bamboo Covered seats, Smoothed and painted panels, Stereo system and a few other bolt on mods. Let me know some opinions...

 

Been a LOOOONG while sine you've posted. Every time I see a pic of your HHR I can't get over the flames.

what else are you looking to do?

 

Over the top & very cool!!! Dig the taillights!

 

Well the plans are still to uni bodydrop the rear so it sits level, and going to add more molded and fiberglass Tikis in the interior, and maybe add a couple of Tvs. the rest I think will just intail some detail like some step covers and engine dress up , I want to custom the side veiw mirrors but cant decide what I want to do with them yet. I have the surfboard rearveiw mirror. and I was thinking of adding a surfboard and rack to the top. Any suggestions?

 

You can now get chrome mirror caps aftermarket. I think two of the supporting vendors her sell them. You'll also find engine dress up there. Which as a matter of fact I do a little of. I powder coat valve covers and CGS intakes. The look sweet. Did a bunch for members here. a few pics are in my gallery. I've used some of the dress up pieces available and have a powder coated valve cover and CGS intake. Makes for a very nice looking engine compartment.

If this is a driver, be careful adding roof rails. It's been said that HHRs with roofrails have a better supported roof. I don't know if that's true. I've seen an HHR with a board on top, up close, very cool! check out the gallery for Big Kahuna.

My next project is smoothing and painting all the interior panels like you've done.

 

Smoothing out the panels is a long long process, and sucks to do the work...lol, but the end resault is just way too cool...not too.

 

I would like to see a custom rear roll pan and a custom front end. Other then that, it looks sick!

 

I want to change to the Facsia Front bumber the pteazers carry, I want to do somthing with the rear bumper but I dont like how flat it looks with just a roll pan. Thank for the response

 

for the unibody drop...did you raise the strut towers and gut the fender wells? does it lay?

on the rear i was noticing that modifying and raising the spring perch about 2-3" (mock C-notch) along with a mini tub we can possibly lay the rear. whats your general consensus on that?

 

AIRDHHR......

Were you at the Alsa show last June? I think I remember your car from there.