how about these https://www.chevyhhr.net/forums/deleted-threads-41/sold%2Als-steel-wheels-covers-33733/

 

hmmm i bet i could get a set of steel stock wheels for cheap and get them powdercoated or painted red will look good with the circles all around now i need to measure for centercaps and rings yeesh how does the tps work with custom rims

 

how about painting your stock steelies, adding trim rings & Chrome lug nuts. Would save some $$$

 

^^^^ and still look sexy. Similar to what I'm going to do.

 

gonna use the stock black rims with ribbed trim rings with the ribs painted red and the baby moons two questions are the stock rims powdercoated or baked and the center dimension i think its called the ouside knob is it 10 and 1/4 " or 8.75" i found baby moons at summit wanna make sure i get the right ones

 

I had someone tell me its 10&3/4" but if I were you, i'd measure again (measure twice, buy once )

 

stock 16" steel rims are 16x6.5" with a 42mm off set.

 

i found these but they say they only have a 32mm offset everything else is right on but would the offset being this far destroy the wheel bearings or just make the wheels sit out a little

 

I'm having this same issue. I'm completely clueless as to what is right for my 2007 LT2.

I do know I have 17 x 7 rims. I need to replace 2 due to stupid road conditions so I figure, eh WTH I will just get 4 new ones! However, Ive been told my backspacing can be anywhere from +35 to a +45. No idea on offset, was told there isn't one. I called the dealer...yea..worthless. I know my bolt pattern is 5/110. If anyone knows the correct offset and backspacing...I would so appreciate it. You would be my hero!

 

I remember seeing someplace that the polished 17"s were 6.5' and the painted 17"s were 7" wide. True or not, no clue. But I remember seeing that someplace.