Chevy HHR Network
Without.
Without.
0 2021/03/03 17:54:06
#8&9
#8&9
0 2021/03/04 11:16:10
It’s routed up there
It’s routed up there
0 2021/03/04 11:17:05
With this kit you reuse the VVT camshaft phasers and the crankshaft sprocket
With this kit you reuse the VVT camshaft phasers and the crankshaft sprocket
0 2021/03/05 05:29:35
9-4202SX is the balance shaft kit , it doesn’t include sprockets , they don’t match the crankshaft sprocket,?so you can’t use it anyways.
9-4202SX is the balance shaft kit , it doesn’t include sprockets , they don’t match the crankshaft sprocket,?so you can’t use it anyways.
0 2021/03/05 05:32:17
0 2021/03/05 05:37:56
Most seals come with this green protector, just tap on that to seat the seal while you have the front cover off the engine.
Most seals come with this green protector, just tap on that to seat the seal while you have the front cover off the engine.
0 2021/03/05 14:13:08
Is everything in its proper position?
Is everything in its proper position?
0 2021/03/06 14:45:35
0 2021/03/08 08:30:13
Mine was red with black vinyl roof
Mine was red with black vinyl roof
0 2021/03/08 14:17:38
0 2021/03/09 05:22:08
The new frame now fits close to the door, the blinds are inside the glass panels
The new frame now fits close to the door, the blinds are inside the glass panels
0 2021/03/09 16:55:24
The wider glass makes a high difference, I forgot to take any before photos
The wider glass makes a high difference, I forgot to take any before photos
0 2021/03/09 16:55:37
I was concerned the door handle and deadbolt were gonna be in the way, they weren’t
I was concerned the door handle and deadbolt were gonna be in the way, they weren’t
0 2021/03/09 16:55:45
Nice to let the light in but not direct sunlight, the glass is UV blocking tinted
Nice to let the light in but not direct sunlight, the glass is UV blocking tinted
0 2021/03/09 16:55:52
Fuel injector harness
Fuel injector harness
0 2021/03/10 13:19:48
Just for #1 cylinder, follow the wires by colour back to the other end of the harness and test the wires with the ohm meter
Just for #1 cylinder, follow the wires by colour back to the other end of the harness and test the wires with the ohm meter
0 2021/03/10 13:24:39
0 2021/03/10 14:01:44
Crankshaft front cover seal , oil leak.
Crankshaft front cover seal , oil leak.
0 2021/03/11 06:03:48
The oil pressure sender is above the starter, but the oil can run along the block and down to the floor , if the shotgun side is lower.
The oil pressure sender is above the starter, but the oil can run along the block and down to the floor , if the shotgun side is lower.
0 2021/03/11 06:05:50
0 2021/03/11 17:33:05
The Bullet style ARE rims were popular a few years back
The Bullet style ARE rims were popular a few years back
0 2021/03/13 05:01:53
This was taken the day he picked it up.
This was taken the day he picked it up.
0 2021/03/13 08:32:53
Even slack like this is enough to bust up the front guide and cause it to idle rough.
Even slack like this is enough to bust up the front guide and cause it to idle rough.
0 2021/03/13 14:29:51
The shower corner and ceiling
The shower corner and ceiling
0 2021/03/16 05:54:31
The plumbing rough in
The plumbing rough in
0 2021/03/16 05:54:38
25 2 X 4’s ....$ 225.00 please! That’s right $9.00 each !!
25 2 X 4’s ....$ 225.00 please! That’s right $9.00 each !!
0 2021/03/16 05:54:45
0 2021/03/16 09:06:16
0 2021/03/16 16:28:13
0 2021/03/16 16:30:04
Note the notches for the pins to line up the VVT phasers
Note the notches for the pins to line up the VVT phasers
0 2021/03/16 16:31:24
Note the phaser timing marks 2 o’clock on the intake and 10 o’clock on the exhaust You might be 180 degrees out.
Note the phaser timing marks 2 o’clock on the intake and 10 o’clock on the exhaust You might be 180 degrees out.
0 2021/03/16 16:33:02
See the raised line just above and to the right of the oil pump spring housing , just below the 10 KW marking
See the raised line just above and to the right of the oil pump spring housing , just below the 10 KW marking
0 2021/03/16 16:39:55
Thanks, I’m building an alcove wall , that’s where the vanity will be .
Thanks, I’m building an alcove wall , that’s where the vanity will be .
0 2021/03/18 08:23:30
The wall is not fully studied, because the shower stall isn’t here yet, and I don’t know if it’s assembled and to big for the doorway.
The wall is not fully studied, because the shower stall isn’t here yet, and I don’t know if it’s assembled and to big for the doorway.
0 2021/03/18 08:23:38
They have been known to melt.
They have been known to melt.
0 2021/03/18 14:41:19
Who thinks we’re rude???
Who thinks we’re rude???
0 2021/03/19 14:03:15
0 2021/03/19 17:09:54
Just googled 90 degree o2 defouler
Just googled 90 degree o2 defouler
0 2021/03/19 17:14:50
Eh!, we like our beer cold up here!
Eh!, we like our beer cold up here!
0 2021/03/20 04:40:27