Chevy HHR Network
0 2020/06/25 10:26:29
0 2020/06/25 10:37:48
0 2020/06/25 12:33:24
0 2020/06/25 13:40:56
Ground stud, part 3 down to the right of the oil filter cap.
Ground stud, part 3 down to the right of the oil filter cap.
0 2020/06/25 18:26:30
0 2020/06/25 18:29:29
The red connection at the fuse box
The red connection at the fuse box
0 2020/06/26 05:31:37
0 2020/06/26 05:47:47
0 2020/06/26 05:51:25
Old bearing for strut mounting plate on the left new one on the right
Old bearing for strut mounting plate on the left new one on the right
0 2020/06/26 11:54:03
Nice new strut mounting plate new rubber isolator inside
Nice new strut mounting plate new rubber isolator inside
0 2020/06/26 11:54:11
Old FE3 9 year old strut
Old FE3 9 year old strut
0 2020/06/26 11:54:19
A little crud on the old strut and the sway bar end link stayed attached.
A little crud on the old strut and the sway bar end link stayed attached.
0 2020/06/26 11:54:28
New KYB strut
New KYB strut
0 2020/06/26 11:54:35
Where the old passenger side strut lived
Where the old passenger side strut lived
0 2020/06/26 11:54:43
Note how your strut goes up in there, where that flat spot goes
Note how your strut goes up in there, where that flat spot goes
0 2020/06/26 11:54:53
The mounting bolts only go in one way
The mounting bolts only go in one way
0 2020/06/26 11:55:02
Drivers side R new KYB strut, yes there’s an R stamped in the swaybar tab , you really can’t mess these up
Drivers side R new KYB strut, yes there’s an R stamped in the swaybar tab , you really can’t mess these up
0 2020/06/26 11:55:11
Moog strut mount part number, yes , made in China
Moog strut mount part number, yes , made in China
0 2020/06/26 11:55:18
KYB made in the USA
KYB made in the USA
0 2020/06/26 11:55:25
Same with this one
Same with this one
0 2020/06/26 11:55:32
Moog sway bar end links made in Mexico
Moog sway bar end links made in Mexico
0 2020/06/26 11:55:38
New PowerStop brake pads, come with new hardware
New PowerStop brake pads, come with new hardware
0 2020/06/26 11:55:45
The larger red wire or that smaller wire to the solenoid?
The larger red wire or that smaller wire to the solenoid?
0 2020/06/26 12:14:10
0 2020/06/26 12:54:06
0 2020/06/26 14:06:13
Part #5 , you will need to remove the axle nut and the three hub bolts , then re torque the three bolts to 85 ft/lbs and the axle nut to 155 ft\lbs the brake caliper bracket bolts are 85 ft/bs the caliper bolts are 25 ft/lbs
Part #5 , you will need to remove the axle nut and the three hub bolts , then re torque the three bolts to 85 ft/lbs and the axle nut to 155 ft\lbs the brake caliper bracket bolts are 85 ft/bs the caliper bolts are 25 ft/lbs
0 2020/06/26 17:40:12
See the crack in this cable clamp?
See the crack in this cable clamp?
0 2020/06/27 06:47:07
Arrow 2 points to it
Arrow 2 points to it
0 2020/06/27 08:58:55
0 2020/06/27 09:35:54
0 2020/06/27 09:37:18
0 2020/06/27 10:08:23
This is the TSB splash shield, to replace the little ones from earlier years , just replaced a set on an HHR built in 2005
This is the TSB splash shield, to replace the little ones from earlier years , just replaced a set on an HHR built in 2005
0 2020/06/27 17:46:16
0 2020/06/27 17:54:13
0 2020/06/28 05:22:57
0 2020/06/28 05:24:56
Piece of pipe for extra leverage
Piece of pipe for extra leverage
0 2020/06/28 05:26:54
It’s the plate between the mount and coil , evidently rust scales are in there jamming it up.
It’s the plate between the mount and coil , evidently rust scales are in there jamming it up.
0 2020/06/28 05:47:07
0 2020/06/28 06:09:39
Nice shout out to Shemp Howard, the fourth stooge.
Nice shout out to Shemp Howard, the fourth stooge.
0 2020/06/28 06:13:00