Chevy HHR Network
0 2020/06/30 08:45:15
0 2020/06/30 05:48:22
0 2020/06/30 05:15:20
0 2020/06/29 19:57:13
0 2020/06/29 10:50:40
0 2020/06/29 10:43:57
0 2020/06/29 05:33:46
0 2020/06/28 14:43:12
This was enough slack to trigger P0014 in my 2011 2.4
This was enough slack to trigger P0014 in my 2011 2.4
0 2020/06/28 14:07:34
Order one of these front guide upper replacement bolts.
Order one of these front guide upper replacement bolts.
0 2020/06/28 14:07:26
0 2020/06/28 06:25:24
0 2020/06/28 06:19:53
Nice shout out to Shemp Howard, the fourth stooge.
Nice shout out to Shemp Howard, the fourth stooge.
0 2020/06/28 06:13:00
0 2020/06/28 06:09:39
It’s the plate between the mount and coil , evidently rust scales are in there jamming it up.
It’s the plate between the mount and coil , evidently rust scales are in there jamming it up.
0 2020/06/28 05:47:07
Piece of pipe for extra leverage
Piece of pipe for extra leverage
0 2020/06/28 05:26:54
0 2020/06/28 05:24:56
0 2020/06/28 05:22:57
0 2020/06/27 17:54:13
This is the TSB splash shield, to replace the little ones from earlier years , just replaced a set on an HHR built in 2005
This is the TSB splash shield, to replace the little ones from earlier years , just replaced a set on an HHR built in 2005
0 2020/06/27 17:46:16
0 2020/06/27 10:08:23
0 2020/06/27 09:37:18
0 2020/06/27 09:35:54
Arrow 2 points to it
Arrow 2 points to it
0 2020/06/27 08:58:55
See the crack in this cable clamp?
See the crack in this cable clamp?
0 2020/06/27 06:47:07
Part #5 , you will need to remove the axle nut and the three hub bolts , then re torque the three bolts to 85 ft/lbs and the axle nut to 155 ft\lbs the brake caliper bracket bolts are 85 ft/bs the caliper bolts are 25 ft/lbs
Part #5 , you will need to remove the axle nut and the three hub bolts , then re torque the three bolts to 85 ft/lbs and the axle nut to 155 ft\lbs the brake caliper bracket bolts are 85 ft/bs the caliper bolts are 25 ft/lbs
0 2020/06/26 17:40:12
0 2020/06/26 14:06:13
0 2020/06/26 12:54:06
The larger red wire or that smaller wire to the solenoid?
The larger red wire or that smaller wire to the solenoid?
0 2020/06/26 12:14:10
New PowerStop brake pads, come with new hardware
New PowerStop brake pads, come with new hardware
0 2020/06/26 11:55:45
Moog sway bar end links made in Mexico
Moog sway bar end links made in Mexico
0 2020/06/26 11:55:38
Same with this one
Same with this one
0 2020/06/26 11:55:32
KYB made in the USA
KYB made in the USA
0 2020/06/26 11:55:25
Moog strut mount part number, yes , made in China
Moog strut mount part number, yes , made in China
0 2020/06/26 11:55:18
Drivers side R new KYB strut, yes there’s an R stamped in the swaybar tab , you really can’t mess these up
Drivers side R new KYB strut, yes there’s an R stamped in the swaybar tab , you really can’t mess these up
0 2020/06/26 11:55:11
The mounting bolts only go in one way
The mounting bolts only go in one way
0 2020/06/26 11:55:02
Note how your strut goes up in there, where that flat spot goes
Note how your strut goes up in there, where that flat spot goes
0 2020/06/26 11:54:53
Where the old passenger side strut lived
Where the old passenger side strut lived
0 2020/06/26 11:54:43
New KYB strut
New KYB strut
0 2020/06/26 11:54:35
A little crud on the old strut and the sway bar end link stayed attached.
A little crud on the old strut and the sway bar end link stayed attached.
0 2020/06/26 11:54:28