New performance mod for the 2.2 enignes...
08-07-2007, 05:28 PM
#1
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Tucson, AZ
Posts: 1,059
New performance mod for the 2.2 enignes...
So, looks like another break-through for the 2.2 guys. Appearantly the intake manifold on the 2.4 is a little different than on the 2.2's. It flows better and has much larger intake runners. Average power shows a drop of about 2 horses or so until 4500 where the power starts to climb. The dyno graph shown on the Cobalt site listed this as making a peak of 16-20 MORE horses at 5500-6500 (redline). 
Here's the post....
Crate Engine Depot makes a kit for this application. Includes the manifold, adapter, and all gaskets. Along with instructions for install. Crate Engine Depot 2.4 Manifold
Here's the post....
3 Baseline runs were performed on the 11th of July all showing an average of 138Hp & 139Tq
3 Runs with the manifold installed were done the following Tuesday night as most of you have seen Tom from crate engine depot posted the graphs. The average being 151Hp & 142Tq
Nothing else was changed on the car between the Baseline and the 2.4 manifold install, even on the same tank of fuel.
Now keep in mind not looking at MAX peak (thought they increased as well) @ 6200 RPM there is a 21Hp and 18Tq increase.
Baseline Dyno
After 2.4L Manifold installed (no other changes)
All runs overlayed
3 Runs with the manifold installed were done the following Tuesday night as most of you have seen Tom from crate engine depot posted the graphs. The average being 151Hp & 142Tq
Nothing else was changed on the car between the Baseline and the 2.4 manifold install, even on the same tank of fuel.
Now keep in mind not looking at MAX peak (thought they increased as well) @ 6200 RPM there is a 21Hp and 18Tq increase.
Baseline Dyno
After 2.4L Manifold installed (no other changes)
All runs overlayed
Last edited by en0oNmAI; 08-10-2007 at 04:49 PM.
$234.86 
08-07-2007, 06:29 PM
#6
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Tucson, AZ
Posts: 1,059
So far as long as its a Cobalt/HHR ECOtec everything fits. From the 2.0, 2.4 and the 2.2 almost all parts are interchangeable (header, intake manifold, etc) Exhausts for the Cobalts need modification to the hangers only. The bends are the same. We drive a Cobalt Retro Wagon.
