Sides in place.


Tailgate bent and top tube tacked.

 

Looks Good Tom, long wheelbase ought to have a nice ride too..

 

Stake pockets ready for one side, now for the top tube. Tailgate is ready for hinge mounting. I know I was going to go with a wood flatbed but had some 16ga that was begging to be used.

 

The coolness continues to grow, outstanding work, killer rod!

 

Thinking of this for the door


One more bend to front side and some trimming and 2 tubes to go and all of the bends are using 2 heavy angles, the back cross frame and a dead blow hammer..


Floor in the bed, might get wood floor later. Remounted the gas tank forward and lower.

Yes I changed my mind on the bed floor but it still may get a wood flat bed and sides later depending on how this looks finished.

 

Lovin' that logo Tom, its really coming together well, great job.

 

I am told my new seat back panel will arrive in the morning so I can get the front box panel bent and formed to the seat back. I have started on wiring.

 

Shortened my windshield supports, note one long one short.


Both done


Dash work


Electronic speedometer.


I would hope a 5.3 LS engine (327) should make it go at least 35 mph!!

 

A nice addition Note the Chevy red/orange for the powered by chevy!!

 

Very Nice Tom............Fomoco in Chevy colors..