Well I got a p2261 CEL about a month ago regreased my forge all is good for about 2-3 weeks. CEL pops up again so im flustered at this point took it off checked all my vac lines tank is holding pressure. But anyway i took the forge aprt again to check everything and bam the o ring is broke think thats causing the CEL?

 

try a new O ring, we will see.

 

yea i emailed them, im gonna put the stock bpv back in today. Think itll mess with my tune at all? I dont see why It would.

 

No it should do fine.

 

O rings need a little bit of lube, or they will break every time. On your new one just give it a rub between your fingers with just a dot of oil. Just enough to make it shiny.

 

Heres a pic the forge it will not hold vacuum when I do the test (push the piston in and cover the nipple hole then piston will just fall back rather than staying in place). This gasket goes between the cap and BPV, its broke or missing a little piece.

 

You can probably find that O-ring at your local auto parts store.

 

Yea i put the stocker back in for now did about 5+ pulls today and plugged in my tuner and no codes as of right now. I emailed forge and asked for a rebuild kit. I think my green spring is junk cause I tested the forge today and it passed with the yellow spring but failed with the green spring.