Chevy HHR Network
The one in the right, it’s separated from the metal barrel the bolt goes through
The one in the right, it’s separated from the metal barrel the bolt goes through
0 2021/11/02 16:25:23
0 2021/11/03 16:49:54
There the grey piece with the hose bib, it should be closed
There the grey piece with the hose bib, it should be closed
0 2021/11/04 15:07:44
Better then repossessed!
Better then repossessed!
0 2021/11/05 08:26:05
No room behind or beside Sweetie’s Terrain
No room behind or beside Sweetie’s Terrain
0 2021/11/05 13:45:35
This photo from the IIHS shows the side airbags do go down those A pillars
This photo from the IIHS shows the side airbags do go down those A pillars
0 2021/11/06 07:02:39
See this ones a 2LT
See this ones a 2LT
0 2021/11/07 06:35:14
Here’s the photo! And the CEL didn’t lite up! More testing later after sunset!
Here’s the photo! And the CEL didn’t lite up! More testing later after sunset!
0 2021/11/07 08:00:37
Close! Rich!
Close! Rich!
0 2021/11/07 08:21:20
The backup light maybe to large, 2012 Orlando
The backup light maybe to large, 2012 Orlando
0 2021/11/08 08:09:19
These 2009 Camaro back lights are just right for either just under the reflectors or replace the reflectors.
These 2009 Camaro back lights are just right for either just under the reflectors or replace the reflectors.
0 2021/11/08 08:09:27
A smaller backup single lamp from a 2015 Mustang might work!
A smaller backup single lamp from a 2015 Mustang might work!
0 2021/11/08 08:09:29
Like this , but no lamp in the tailgate. And the backup lights either beside the license plate or down below the reflectors
Like this , but no lamp in the tailgate. And the backup lights either beside the license plate or down below the reflectors
0 2021/11/08 08:36:05
0 2021/11/08 09:02:53
Here’s a photo with the subframe removed, see the cage.
Here’s a photo with the subframe removed, see the cage.
0 2021/11/08 09:51:50
This is a Moog K80567 ball joint for an LS FE1/ LT FE1 and FE3 HHR, note the calliper measurement in metric of 19.9 mm. Too small for the SS FE5. Our moderator RJ will post a photo of his SS LCA and the ball joint stub diameter.
This is a Moog K80567 ball joint for an LS FE1/ LT FE1 and FE3 HHR, note the calliper measurement in metric of 19.9 mm. Too small for the SS FE5. Our moderator RJ will post a photo of his SS LCA and the ball joint stub diameter.
0 2021/11/08 11:40:30
The rears fit fine with or without running boards
The rears fit fine with or without running boards
0 2021/11/08 13:36:03
The front also fit great with or without running boards
The front also fit great with or without running boards
0 2021/11/08 13:36:05
These were Boydies reverse lights in the reflectors
These were Boydies reverse lights in the reflectors
0 2021/11/09 04:32:47
An example of flush mount led lights
An example of flush mount led lights
0 2021/11/09 04:37:14
0 2021/11/09 14:47:29
0 2021/11/09 14:47:31
Or this stud extraction device.
Or this stud extraction device.
0 2021/11/09 14:48:21
Please remember the fallen and the heroes who fought to give us peace and freedom! Thank a veteran!
Please remember the fallen and the heroes who fought to give us peace and freedom! Thank a veteran!
0 2021/11/11 06:56:35
Note that is just $7.20 CDN funds! For those AC Delco bushings, clean the bar of any dirt and grease, install them clean , no grease! With the split facing to the rear of the car.
Note that is just $7.20 CDN funds! For those AC Delco bushings, clean the bar of any dirt and grease, install them clean , no grease! With the split facing to the rear of the car.
0 2021/11/13 11:03:23
These are my 2LT aluminium rims with the black Gorilla lug nuts
These are my 2LT aluminium rims with the black Gorilla lug nuts
0 2021/11/13 14:47:16
Like these 2LT chrome over plastic 17 inch rims?
Like these 2LT chrome over plastic 17 inch rims?
0 2021/11/15 14:29:16
HHR shaft top and Cobalt shaft bottom
HHR shaft top and Cobalt shaft bottom
0 2021/11/18 04:50:30
Note the yoke length on the Cobalt shaft
Note the yoke length on the Cobalt shaft
0 2021/11/18 04:50:32
Here’s the HHR shaft , note the yoke length The Cobalt shaft was packaged incorrectly in the GM package labeled for the HHR.
Here’s the HHR shaft , note the yoke length The Cobalt shaft was packaged incorrectly in the GM package labeled for the HHR.
0 2021/11/18 04:50:34
0 2021/11/18 09:11:47
0 2021/11/18 09:11:50
I know this isn’t an SS but same rad brackets
I know this isn’t an SS but same rad brackets
0 2021/11/21 12:15:51
Here’s what to look for to replace that burnt melted bulb socket
Here’s what to look for to replace that burnt melted bulb socket
0 2021/11/22 12:42:36
From all of us here at chevyhhr.net and Internet Brands! Have a safe and Happy Thanksgiving
From all of us here at chevyhhr.net and Internet Brands! Have a safe and Happy Thanksgiving
0 2021/11/25 10:25:25
Like this , only on top of the cubby box door.
Like this , only on top of the cubby box door.
0 2021/11/29 05:49:32
And this isn’t a distracting screen in this 2021 Tesla model 3 ? I agree about putting it on top over the cubby cover. I’m old school , turn around and look out the back windows! No guessing what’s back there!
And this isn’t a distracting screen in this 2021 Tesla model 3 ? I agree about putting it on top over the cubby cover. I’m old school , turn around and look out the back windows! No guessing what’s back there!
0 2021/11/29 08:47:10
This stretched timing chain, from EBay, a cheap $35.00 kit. Not worth it! It could have cost me the engine!
This stretched timing chain, from EBay, a cheap $35.00 kit. Not worth it! It could have cost me the engine!
0 2021/11/29 12:59:12
Check out RockAuto, under electrical connectors and don’t forget the discount code
Check out RockAuto, under electrical connectors and don’t forget the discount code
0 2021/12/01 04:49:49
0 2021/12/01 13:47:51