THE BATMAN

How did you finnaly get off the stock knob ?

gcsd3742

We grabbed a big pair of Channel locks grab it twisted, BADA BING BADA BOOM it came off.. GM got some great glue on that thing.

THE BATMAN

Thanks, that'll work. 1 more ? - how did you realease the boot froom the reverse trigger ?

gcsd3742

There's a Tie wrap on the top of the boot snip it and the reverse lever theres a clip there put in a screwdriver and pop it off...

THE BATMAN

Thank you sir , The TWM looks Great !

gcsd3742

Thanks...

Yonash

that is the standard shifter that comes with the SS kit, aluminum, lightweight, and yes, engraved with the H-pattern.

i just kept prying with the screwdrivers like the instructions say to. it's a slow and tough process, but it works. the channel locks mentioned seem like a good alternative.

c2vette

One note for you folks in the cold climate. You'll need driving gloves in the morning. Once the aluminum knob cold soaks it will just about give you frost bite, even gets a bit chilly here in California. The stainless would be a little better since it has lower thermal conductivity, but a leather cover might be the ultimate way to go.

gcsd3742

[quote=Yonash;343668]that is the standard shifter that comes with the SS kit, aluminum, lightweight, and yes, engraved with the H-pattern.

Mine is the TWM performance short throw shifter. factory is plastic and leather shift knob

Yonash

[QUOTE=gcsd3742;343756]i know, lol. i was responding to Dr Loch. hence why i put it is the standard shifter that comes with the SS kit. those pictures are my shifter, that i just installed. i started this thread.