Hello:

I was wondering---I am getting a pre-painted factory spoiler and I am going to attempt to install it myself (I put one on a 99 monte carlo with no problem---but then--that had a trunk).

I have the general instructions--but---when it comes to the top of the liftgate where it will be installed---usually one must drill holes at the outside intended location---then attach from the inside into the spoiler legs via a larger drilled inside hole.

When one opens the liftgate---the upper portion has what seems to be two rubber plugs on the corners---what do these open to and is it possible to use the openings as the inside holes to attach the spoiler w/o having to drill two more holes?

anyone done this? thx for any advice.

thx


PS: great forum---lots of info and excellant advice


Peace to you all!!

 

Try this thread may help. If not try the search feature for rear spoiler.

https://www.chevyhhr.net/forums/appearance-modifications-discussions-6/premier-edition-spoiler-9499/

 

thx very much for that

 

You are welcome.