I screwed up and forgot to measure before, but I'd say at least 2" up front, 2-1/2 in the back. The rear still sits about a half inch higher in the rear but it looks good. And yes, these are the Canucks that are made for the cobalt SS model.

 

Here's a little better pic...

 

Awesome man! Thanks for the pics too. That's the route I'm goin for lowering springs.

 

unfortunately I failed to measure too. And it's odd I know because most said you got little to no front drop also but here's a pic compare to chefs above for reference. I unfortunately didn't do pre drop measurements but It's very noticeable.

 

Hey chef, you asked about the ride height. I took some quick pics this afternoon. Pardon the quality it was raining and my phone wouldn't focus good. I measured from ground at center of each wheel to the bottom center of quarter panel. Fronts came out to a shade over 26" just barely over. Rears came out to just a shade under 26.5" inches. Here are pics.

 

Looking good prince and thanks again for the tips on painting the front hubs. My steelies are looking sharp!

 

Thanks nrvous :-) glad I could be of help. I find this board in general has been amazing for ideas and useful info. I checked out your pics looking good