What Did You Do To Your HHR Today?
Member
Joined: 09-27-2009
Posts: 83
From: nORcAL
I just bought 100 sq ft of 70 mil sound proofing from eBay and also a few rolls of the peel and seal stuff from home depot.
Two 12's in the trunk really bring out the shortcomings of the body noise as expected.
Now the large task of completely stripping interior and panels to get nuts with the dynamat is on my short list.
Two 12's in the trunk really bring out the shortcomings of the body noise as expected.
Now the large task of completely stripping interior and panels to get nuts with the dynamat is on my short list.
Senior Member
Joined: 04-26-2012
Posts: 204
From: Pikeville, ky
Installed the rear ss/SC springs, rotated my tires, painted the hubs, and went with the exposed 5 spoke wheel look. I go in the morning to get my front springs installed since my spring compressor is mia.
Rest In Peace
Joined: 06-13-2010
Posts: 2,301
From: IL.
Hand washed Morticia, then used the Porter Cable VS dual action buffer and Meguiars SwirlX swirl remover on her. Was Overdue for the swirl removing.
Gonna put a fresh coat of Meguiar's Ultimate Liquid Wax on her next.
Shine Shine Shine!
Gonna put a fresh coat of Meguiar's Ultimate Liquid Wax on her next.
Shine Shine Shine!
Senior Member
Joined: 06-11-2012
Posts: 265
From: Oak Ridge, TN
Loaded up the firearms and went to the range this morning and of course mud puddles were everywhere. So when I got home I tossed the bath water on Chubbs and srcubbed his butt down with a soft towel drying. I plan to ponder around the engine bay looking around and what not and check the tire pressure, then to do a complete front end suspension check. May even decide to change the oil and check the plugs....
Senior Member
Joined: 04-20-2011
Posts: 857
From: Ohio
A&P- I guess that you weren't the only one polishing over the weekend!
I tried out my new Cyclo 2 headed 4" orbital polisher. Smooth! Now I have a 3" air,the cyclo, and the old faithful direct drive full size black and decker buffer. Too many tools not enough time!...john And I wanted to ask you how the S/S headlight trim worked out?
I tried out my new Cyclo 2 headed 4" orbital polisher. Smooth! Now I have a 3" air,the cyclo, and the old faithful direct drive full size black and decker buffer. Too many tools not enough time!...john And I wanted to ask you how the S/S headlight trim worked out?
Senior Member
Joined: 02-16-2012
Posts: 148
From: Oldsmar, Florida
Gave mine a nice hand wash (mothers wash & wax) and spray detail (meguires)
and when I finished vacuuming it out the rain began. Oh well at least its is clean.
Happy HHR_ing everyone,
and when I finished vacuuming it out the rain began. Oh well at least its is clean.
Happy HHR_ing everyone,
Last edited by kb0sdq; Jul 31, 2012 at 09:53 PM.
Senior Member
Joined: 10-21-2008
Posts: 1,831
From: hemet, calif.
Went out last night about 4 miles from home the HHR would not start, glad I havea batteryjump start bought from Harbor Freight started right up the DIC was showing battery saver on- check battery chargeing system the power stearing was a little harder to turn, got home car in the garage trird to restart, maybe time for a new battery,
