2006 grill fit on 2007?
05-18-2009, 05:37 PM
#11
Senior Member
Join Date: 02-13-2009
Location: Bakersfield, CA
Posts: 141
Aha! So it be pictures you wanting, eh? Well, here are a couple of photos of my secret project, to wet your whistle, so to speak!
The naked car:
The rear passenger side of lower bar:
Front passenger top showing cuts of the upper bar:
The front of grill showing modifications of the bowtie area:
These will just have to do. It's a secret project.
The naked car:
The rear passenger side of lower bar:
Front passenger top showing cuts of the upper bar:
The front of grill showing modifications of the bowtie area:
These will just have to do. It's a secret project.
05-19-2009, 06:32 AM
#12
Senior Member
Join Date: 03-14-2009
Location: Youngsville, North Carolina
Posts: 262
Looks good so far. It appears you're leaving the top and bottom bar uncut, unlike the guy with the red one. Sorry, if I forgot his name.
Anyway, once you get the grille finished, then you have to modify your front fenders for round headlights to fit the theme of that hood ornament.
Anyway, once you get the grille finished, then you have to modify your front fenders for round headlights to fit the theme of that hood ornament.
05-19-2009, 08:05 AM
#14
Senior Member
Join Date: 08-29-2008
Location: NorCal BayArea
Posts: 936
Thanks for the Compliments Czechman 
! Uncle Dannie carefull of the Cut Plastic as you probably already know that stuff is "SHARP" 
! Are you planin on removing your Bow-Tie 
? If I give anyone a tip attempting this mod it is to under cut everywhere 
! Once you remove any material (trying to use minimal amount of filler) it's hard to go back 
!
Good Luck,
! Uncle Dannie carefull of the Cut Plastic as you probably already know that stuff is "SHARP" ! Are you planin on removing your Bow-Tie ? If I give anyone a tip attempting this mod it is to under cut everywhere ! Once you remove any material (trying to use minimal amount of filler) it's hard to go back !Good Luck,
Last edited by DLVRNIT; 05-19-2009 at 09:41 AM.
05-19-2009, 12:01 PM
#15
Senior Member
Join Date: 02-13-2009
Location: Bakersfield, CA
Posts: 141
Au Contraire, Czechman, all I have to do is cut out round holes in white vinyl and stick them over the headlights.
Hey DLVRNIT. I spent all day yesterday on my hands and knees, picking up little pieces of plastic and gluing them back onto the grill. Went through two bottles of Elmer's Glue.
Hey DLVRNIT. I spent all day yesterday on my hands and knees, picking up little pieces of plastic and gluing them back onto the grill. Went through two bottles of Elmer's Glue.
!
Thread
Thread Starter
Forum
Replies
Last Post