donbrew

Don't have ABS??????

RJ_RS_SS_350

I remember reading on the Cobalt forums, some were snapping axle shafts when they upgraded their LSJs.

OshawaHHRss

no, i have no vss, abs, or esc. Dont really need any of that stuff anyways. I use gps for speed and it doesnt bother me not having esc or abs

OshawaHHRss

i suspect that might have been a driver mod issue. Full send while wheel hopping. I might use a vue intermediate shaft and get dss to make me a custom passenger side axle. Id rather run base model axles than dss though

Scott Fitzgerald

yes I realize thread os old but if theres a chance to get an answer l try it. Currently doing a auto to manual swap . The dash is completely out but can't figure out how to remove pedal assembly. Any help is appreciated. Thanks
in advance

donbrew

Does this help?

Oldblue

Please read and look at the photos in post #1 , as you’ll see he does say he removed the dashboard and the drivetrain to remove the pedal assembly. You can also send a PM to the OP and ask questions.

donbrew

You don't need to do all of that to remove the pedals; You do need to do it to remove the plate they are mounted on to replace it with the one that has a spot for the clutch pedal.

Scott Fitzgerald

Yes it sure does help thank you for posting the picture of clutch pedal assy.. And the plate that it mounts to that's where I was getting lost at. Thanks again for quick response now to cancel my weekend plans and get this thing done

OshawaHHRss

that plate is on back order iirc.